Dibond Hanger
The Dibond Hanger is a self-adhesive hook made of galvanised steel, designed to be mounted on the back of a Dibond, Forex, or Plexiglas panel for easy and secure hanging. It is an accessory intended for use behind the panel and is available in several sizes:
45 × 45 mm, 70 × 70 mm, 100 × 100 mm, and 100 × 200 mm.
The correct size is selected based on the panel's weight. For larger or heavier panels, two Dibond Hangers may be required. Helpful tips and advice can be found below.
The hangers are also available as a complete set, including screws, a wall bracket, and a spacer.
Dibond Hanging System
Choose the appropriate Dibond Hanger based on the panel’s size and weight:
-
45 × 45 mm → max. weight 1 kg
-
70 × 70 mm → max. weight 2 kg
-
100 × 100 mm → max. weight 4 kg
-
100 × 200 mm → max. weight 8 kg
For optimal stability—especially with larger panels—two hangers may be required.Complete sets with screws, brackets, and spacers are also available.
Instructions for Use
Step 1: Ensure the area where the Dibond Hanger will be applied is clean and free of grease. Use alcohol to degrease the surface and allow it to dry completely.
Step 2: Apply the Dibond Hanger to the cleaned area on the back of the panel.
Step 3: Place a weight on top of the hanger and allow it to cure for 72 hours.
After curing, the panel is ready to be hung. Dibond Hangers can also be used with our picture-hanging systems, ensuring your walls remain undamaged.
